Numéro |
Rev. Phys. Appl. (Paris)
Volume 5, Numéro 2, avril 1970
|
|
---|---|---|
Page(s) | 283 - 286 | |
DOI | https://doi.org/10.1051/rphysap:0197000502028300 |
DOI: 10.1051/rphysap:0197000502028300
Étude et réalisation d'un polariseur circulaire d'ondes hyperfréquence à forte tenue en puissance
J. Deschamps, M. Fitaire et D. PagnonLaboratoire de Physique des Plasmas , Faculté des Sciences, 91, Orsay
Abstract
A special fabrication technique has been used to construct a high frequency S-Band (3 000 MHz) circular wave polariser. The circularly polarised wave is obtained by sending two linearly polarised waves through a wave guide which has an elliptical cross-section, the polarisation of each wave being parallel to one of the principal axes of the ellipse. The fabrication technique used yields an elliptical cross section with a smooth transition to a cylindrical guide. The resulting polariser supports very high power levels (up to 23 MW). A special microwave assembly preceding the polariser yields a circularly polarised wave regardless of the S. W. R. of the termination.
Résumé
Une technique spéciale d'usinage a été mise au point pour réaliser un polariseur circulaire d'ondes hyperfréquence en bande S (3 000 MHz). L'onde circulaire est obtenue en faisant propager dans un guide à section droite elliptique une onde rectiligne orientée dans la direction d'une bissectrice des axes de l'ellipse. La méthode d'usinage utilisée réalise ce guide elliptique tout en assurant une transition progressive avec un guide cylindrique ; un tel polariseur a une très bonne tenue en puissance (jusqu'à 23 MW). Un montage hyperfréquence spécial précédant le polariseur permet d'obtenir avec celui-ci une onde à polarisation circulaire quelque soit le coefficient de réflexion de la charge utilisée.
0630L - Measurement of basic electric and magnetic variables.
4100 - Electricity and magnetism: fields and charged particles.
Key words
microwave devices